Moroso Sealed Plastic Battery Relocation Box

Model Number: 601178
When you stuff your battery in a Moroso sealed battery box, you can locate it just about anywhere you want on your vehicle and not worry about water, dirt, dust, etc. ruining it. This is a very safe battery box compared to the aluminum/steel and homemade battery boxes that are conductive as well!

Accepted by the NHRA and IHRA, these tough polyethylene boxes have an airtight lid, with a foam gasket to keep battery gasses from entering your car's interior (six quick-release fasteners keep the lid on tight).

These boxes come with a vent tube, battery hold-down with 3/8 in. steel rods, rubber cable clamps and grommets, and mounting hardware.

NOTE: Wiring to run between this battery when its installed in the trunk, and the front engine compartment is sold seperately. Be sure to check out our other Moroso wiring kit to make installation easier.

Included components:

  • Battery Box
  • Molded Lid
  • 2 Small plastic grommets
  • 2 Large plastic grommets
  • 1 Zinc plated hold down
  • 2 3/8 nuts
  • 2 3/8 Di. Hold down studs
  • 2 Flat washers
  • 4 3/8 Locking nuts
  • 6 Swell Latch assemblies
  • 2 ft Vent tubing
  • 4 ft EPDM Lid Seal
  • $99.99

    Additional Options

    Moroso Battery Box Wiring Kit

    Model Number: 601179
    These Moroso battery cable kits are just what you need if you are relocating your battery. Their high-grade copper cable Read more

    • Goran
      Is this for standard size battery?
      1 Answer
      • customer service rep

        Yes.
    • Kyle
      Will this kit work with a Neon srt4?
      1 Answer
      • customer service rep

        Its universal, so it will fit on any car as long as you have room for it.
    • Steve
      I was wondering if you guys could send me the demensions to this battery box. Thanks
      2 Answers
      • customer service rep

        Outside Dimensions: 13-1/8" Wide, 11-1/8" Deep, 11-1/8" Tall
      • customer service rep

        Inside dimensions:
        Length (in):10.500 in.
        Width (in):13.000 in.
        Height (in):9.500 in.
    • Justin
      Where do you get the wiring to run the battery to the trunk?
      1 Answer
      • Customer Service Rep

        Use part number 601179 in the search bar to find the corresponding Moroso battery box wiring kit.
    Close