MPx Oil Catch Can, 08-10 Cobalt SS
+ ENLARGE IMAGE
Email iconEmail a Friend

MPx Oil Catch Can, 08-10 Cobalt SS

Review star icon Review star icon Review star icon Review star icon Review star icon
Read or Write Review
Model Number: 601187-COB-KIT

Keep your intake piping clean and free of oily residue with the MPx Oil Catch Can. By intercepting the breather hose from the valve cover this unit will accumulate and collect oil that would other wise end up as intake sludge. The lever controlled drain at the bottom makes emptying a snap and you'll know when it's necessary with the sight tube. Installation is easy and fitment is great with our included bracket and hardware specifically for the Cobalt SS Turbo. There's no drilling or modifications necessary, install should take less than 30 minutes! We include silicone hose to replace the steel braided factory piece.

Note the pictured and assembled catch can. This is recommended placement and orientation of the bracket and fittings but it can be varied slightly.

$119.00

Additional Options

MPx Catch Can Drain Kit
+ ENLARGE IMAGE

MPx Catch Can Drain Kit

Model Number: 601187-DRAINKIT
The MPx catch can kit has a drain valve on the bottom of it to drain out any collected oil. Sometimes it can be Read more

MPx Check Valve 8mm size (Prevent PCV Damage)
+ ENLARGE IMAGE

MPx Check Valve 8mm size (Prevent PCV Damage)

Model Number: 601237
When running higher boost levels, we have seen many cases of PCV valve failures (blowing out its internals into the Read more

MPx Oil Catch Can, 08-10 Cobalt SS, Turbo Accessories: Store Name

Ask a Product Question
  • tim
    will this work on my 2.4 liter 2007 Cobalt SS with the stage 2 to ZZp turbo
    1 Answer
    • customer service rep
      We're not sure. We only designed this for the 08-10 Cobalt SS Turbo, and have not tested this on any supercharged 05-07's.
  • Phil
    Can you provide fittings to convert it from whatever thread pitch the lid has to 2 -10an male fittings? I am setting up my entire system for -10an pcv lines
    1 Answer
    • customer service rep
      We do not have AN fittings for the catch can, sorry.
  • John Giallanza
    Is this a hollow can or does it have proper filter media inside?
    1 Answer
    • Customer Service Rep
      This catch can is not hollow, it is filled with a stainless steel mesh media to trap oil.
  • bill
    Is this product installed by taking the breather hose off of the air intake pipe? Or are you recommending taking hose off of turbo
    1 Answer
    • Customer Service Rep
      Yes, you must remove the breather hose off of the valve cover and intake, and the catch can traps any oil going between the valve cover and intake.
Close