(Discontinued) Mopar OEM MAP Sensor, 03-05 Neon SRT-4 / 03-07 PT Cruiser GT

(Discontinued) Mopar OEM MAP Sensor, 03-05 Neon SRT-4 / 03-07 PT Cruiser GT

July 2023, Mopar discontinued the OEM map sensor. There are no more left. We recommend you get one of the aftermarket OEM style map sensors that we are stocking now, part number 2201119-AFTERMARK. These fit perfectly with the map sensor connector, they have the correct voltage outputs, and are tested to 40 psi, with no problems. The quality is very good.

OEM (Intake manifold location) MAP Sensor for the 03-05 Neon SRT-4 & 03-07 PT Cruiser GT.

(Discontinued) Mopar OEM MAP Sensor, 03-05 Neon SRT-4 / 03-07 PT Cruiser GT, Sensors & Connectors: Store Name
  • Travis
    I have a 05 SRT4 stage 1. When I go to change the map, tip and o2 sensors, will I need to get a tune after. Super noob question from a new SRT owner.
    1 Answer
    • Customer Service Rep
      This listing is for the OEM map sensor. If you replace it, there is no tuning or anything needed. If you go from the OEM map sensor to the 3 bar map and tip sensors, then yes you'll need a Diablosport and custom Diablosport tune because the pcm cant handle the different voltage output from the three bar map sensors.
  • Robert Burrows
    I'm looking to go back to stock but I seen I can't run the 3 bar map on my srt4 but read that with a diablosport custom tune I could run the 3 bar still, so my question is do I need this map sensor and put it on 91 octane tune on my trinity or can i run the trinity 91 tune with the 3 bar?
    1 Answer
    • Customer Service Rep
      This is an OEM map sensor. Use this if you have a factory computer with factory tune. If you have any sort of aftermarket tune that uses 3 bar map sensors this will not work and you should use 3 bar map sensors.
  • Jill
    Can I use this MAP sensor on a 2001 PT Cruiser? I installing an aftermarket and I'm have read issues.
    1 Answer
    • Customer Service Rep
      The angle of the sensor is different, and most importantly the non turbo PT Cruiser uses a 1 bar pressure non turbo sensor, whereas the SRT-4 and GT Cruiser use a turbo 2 bar pressure sensor. They are not compatible.
  • Joseph
    Does this come with the screws to mount it cause i broke one and need to replace it if not what size could it be
    1 Answer
    • Customer Service Rep
      No, this does not come with screws. It comes exactly as shown in the photos: map sensor only. The screw appears to be a M3 bolt, and is a .8 thread pitch. The length is between 10-15mm.
Close