Forge Vented Blow Off Valve, 2013-16 Dart 1.4L / 2012-17 Fiat 500 Turbo/Renegade

Model Number: 225109-VENTED

We offer the Forge Vented Blow Off Valve for the 1.4 Turbo Multiair engine used in many Fiat's and the Dodge Dart.

This is a piston design blow off valve that is a direct replacement for the original fitment. This valve gives greater longevity than the diaphragm (OEM) valves but also benefits from its ability to be fitted with different springs when the boost pressure has been increased or the engine has been modified. To ease installation the top or vacuum connection is angled.

This fits the 1.4 Turbo engine found in the:
  • Fiat 500 (Turbo, and Abarth models)
  • Jeep Renegade
  • Dodge Dart
  • What's included:

    • 1 x FMDVF14A Valve
    • 1 x 2000mm of 4mm Vacuum Tube
    • 1 x 500mm of 6mm Vacuum Tube
    • 1 x Solenoid, Bracket, and Screws
    • 14 x Cable Ties
    • 1 x Uprated Blue Spring
    • 1 x Aluminium Machined Coupler
    • 1 x 4mm T Piece
    • 1 x 6mm T Piece
    • 1 x Wiring Harness
    • 1 x 6mm-4mm Plastic Reducer
    • 1 x M6 Nyloc Nut
    • 1 x Instructions

    *Backordered: 8/21/2020
    $259.99
    • Cody Jenkins
      What all does this replace? Looks like it replaced the boost solenoid?
      And this is an atmospheric blow off valve?
      1 Answer
      • Customer Service Rep

        This system replaces the original diverter, and bypasses the factory boost control with its own solenoid controller. Yes its atmospheric, meaning it releases air like a real blow off valve, it does not recirculate like the factory diverter.
    • Brian schueler
      I looked at my factory blow off valve and there is only an electrical connector going to it. When I buy this will there be anything I have to add in with this bov or where does all the vacuum lines go?
      1 Answer
      • Customer Service Rep

        This kit has a vacuum/boost controlled solenoid that plugs right into your factory wiring. Then you run vacuum wiring from the solenoid to the valve. There are no other parts needed.
    • Bruce Nguyen
      Which one do you recommended between Forge vented blow off valve and Forge recirculating blow off valve? And can I use it with Go Fast Bits diverter? Will it add any power or throttle response?
      1 Answer
      • Customer Service Rep

        You can use either one, there might be a slight performance increase with the recirculate instead of atmospheric release as compressed air would be going back into the turbo instead of to atmosphere. No you cannot use the GFB parts with the Forge vented valve or Recirculating valve , as the GFB only works with the stock diverter valve.
    Close