Moroso Sealed Battery Box for Trunk Battery Relocation

Model Number: 601178

When you stuff your battery in a Moroso sealed battery box, you can locate it just about anywhere you want on your vehicle and not worry about water, dirt, dust, etc. ruining it. This is a very safe battery box compared to the aluminum/steel and homemade battery boxes that are conductive as well!

Accepted by the NHRA and IHRA, these tough polyethylene boxes have an airtight lid, with a foam gasket to keep battery gasses from entering your car's interior (six quick-release fasteners keep the lid on tight).

These boxes come with a vent tube, battery hold-down with 3/8 in. steel rods, rubber cable clamps and grommets, and mounting hardware.

NOTE: Wiring to run between this battery when its installed in the trunk, and the front engine compartment is sold seperately. Be sure to check out our other Moroso wiring kit to make installation easier.

Included components:

Battery Box

Molded Lid

2 Small plastic grommets

2 Large plastic grommets

1 Zinc plated hold down

2 3/8 nuts

2 3/8 Di. Hold down studs

2 Flat washers

4 3/8 Locking nuts

6 Swell Latch assemblies

2 ft Vent tubing

4 ft EPDM Lid Seal

Moroso Sealed Battery Box for Trunk Battery Relocation

Additional Options

Moroso Battery Box Wiring Kit

Ask a Product Question