MPx Blow Off Valve Block Plate, 03-05 Neon SRT-4 / 08-09 Caliber SRT-4

Read or Write Review

Model Number: 220117-MACHINED

Going to install a new blow off valve on your Caliber SRT, Neon SRT, or PT Cruiser GT? You're going to need to install this block off plate to block the factory blow off valve port.

Whats the difference between this style of block off plate and the AGP one? Simple, the AGP is meant to seal with RTV, whereas this one has integrated rubber seals.

This block off plate comes with 2 rubber O-Rings to ensure a nice and tight seal. Even RTV can have small leaks, the beauty is that this piece does not require RTV, which will make for a nice clean installation that can tolerate high pressures.

(This part is not required for Mopar Performance Blow Off Valve plate installation).

$19.99

MPx Blow Off Valve Block Plate, 03-05 Neon SRT-4 / 08-09 Caliber SRT-4, Blow Off Valves & Adapters: Store Name

Ask a Product Question

- *E-mail: (Required)
  *Name: (Required)
  
  Characters remaining: 500
  Our Q&A program is designed to educate our community.
  This is not to answer questions about your orders, or problems you are having with a part you ordered. If you have questions about a part you have already ordered, please contact us by email at info@modernperformance.com or call us 713-270-8520 for faster service.
Darryl

What is the procedure on installing the block off plate and what increase will it have on mi dodge neon SRT4?

1 Answer
- E-mail: Name: (optional)
  
  Characters remaining: 500
  Type your response below:
- Modern Performance
  
  Before installing this block off plate, be sure you have purchased a blow off valve kit. You will have to remove the factory surge valve where three 8mm bolts are holding it. Then replace it with the block off plate, if you can put some high temp silicone around it from leaking. Then tighten it back up and cap off the original vacuumn line.
Zeke

Will this block off plate work with my stage 3 turbo?

1 Answer
- E-mail: Name: (optional)
  
  Characters remaining: 500
  Type your response below:
- Customer Service Rep
  
  The stage 3 turbo from MOpar uses the same OEM diverter valve as the OEM turbo. Therefore, yes, this will work fine.
raleigh

does this kit come with new hardware?

1 Answer
- E-mail: Name: (optional)
  
  Characters remaining: 500
  Type your response below:
- Customer Service Rep
  
  It comes exactly as shown. Block off plate with two o ring gaskets. You reuse your factory bolts.
chance

can i install this and run no blow off valve or would it hurt power on my setup of DSP on 18psi and other bolt ons?

1 Answer
- E-mail: Name: (optional)
  
  Characters remaining: 500
  Type your response below:
- Customer Service Rep
  
  Your SRT-4 needs a blow off valve to operate correctly and not suffer damage to the turbocharger. You can have the factory diverter valve, or you can have an aftermarket diverter in the factory location, or you can install a HKS/Greddy, etc blow off valve on a uppipe. But you can not use this to block off your factory diverter and not have a blow off valve on your car. This is exclusively made for people that are installing a uppipe with blow off valve on their SRT-4 and need to block off the factory diverter port.