Crane Cams Camshafts, 03-05 Neon SRT-4 / 03-07 PT Cruiser GT
Attention: Crane has closed down and we have no more cams left! Sorry!Please check our Crower listings for cams that are available and in stock.
These camshafts start out as billet cores, are ground down, and polished to each camshaft spec sheet. Crane offers a total of 5 grinds for the DOHC Neon, of which we stock. These five grinds will work well for 98% of all DOHC owners. These cams will also work on the 01-10 PT Cruiser 2.4L as well.
The five grinds we offer are as follows.
- #10 Grind - (Discontinued) Good idle, daily usage, good mid range HP, performance upgrade for stock engine, aftermarket intake / exhaust and ECM advised. 1000-6500 Rpm Power Range
- #12 Grind - (Discontinued)
Good idle, performance usage, street, drag race, intended for use with nitrous, aftermarket intake / exhaust and ECM advised. 1500-6800 Rpm Power Range
- #14 Grind - (Discontinued)
Good idle, performance usage, for use with turbo, good upper RPM HP, intercooler advised, aftermarket intake / low restriction exhaust required. 1500-6800 Rpm power range
- #16 Grind - (Discontinued)
Fair idle, performance usage, drag race, good mid and upper RPM HP, high flowing cylinder head/intake/exhaust and aftermarket ECM advised. 2000-7200 Rpm power range
- #18 Grind - (Discontinued)
Performance usage, drag race, good upper RPM HP, high flowing cylinder head / intake / large exhaust advised, 12.0+ minimum compression ratio and aftermarket ECM required. 2500-7500 Rpm power range
Note: You must use performance valve springs with these camshafts. If you do not, your factory valve springs may fail, causing catastrophic damage if the valves were to drop and contact the pistons. It is not worth the risk! Purchase performance valve springs. They're not very expensive.